After standing down on the Artemis I launch attempt Saturday, Sept. 3 due to a hydrogen leak, teams have decided to replace the seal on an interface, called the quick disconnect, between the liquid hydrogen fuel feed line on the mobile launcher and the Space Launch System (SLS) rocket while at the launch pad. Performing the work at …
After standing down on today’s Artemis I launch attempt when engineers could not overcome a hydrogen leak in a quick disconnect, an interface between the liquid hydrogen fuel feed line and the Space Launch System (SLS) rocket, mission managers met and decided they will forego additional launch attempts in early September. Over the next several …
The launch director waived off today’s Artemis I launch attempt at approximately 11:17 a.m. EDT. Teams encountered a liquid hydrogen leak while loading the propellant into the core stage of the Space Launch System rocket. Multiple troubleshooting efforts to address the area of the leak by reseating a seal in the quick disconnect where liquid …
After the third troubleshooting attempt, the liquid hydrogen leak has occurred again. Teams are discussing next steps.
After warming up the area of the liquid hydrogen leak, engineers are once again flowing liquid hydrogen to the core stage.
Engineers are continuing troubleshooting efforts to address a liquid hydrogen leak in a cavity in the quick disconnect where the flight side and ground side plates join. They once again will attempt to warm up the quick disconnect to try to reset the seal. The liquid oxygen tank of the core stage is full and …
A liquid hydrogen leak has reoccurred again in a cavity between the ground and flight side plates of a quick disconnect in the engine section. Teams are discussing additional troubleshooting efforts.
Launch controllers have started flowing liquid hydrogen to the core stage again after troubleshooting the reoccurrence of a leak. This time engineers attempted to reseat the seal in a quick disconnect cavity where the leak occurred by applying pressure to it with helium.
As engineers increased the pressure on the flow of liquid hydrogen into the core stage, a leak reoccurred. Engineers will attempt to reseat the seal in the quick disconnect cavity where the leak has been detected. This time they will stop flowing liquid hydrogen to the tank, close the valve used to fill and drain …
Launch controllers have resumed flow of liquid hydrogen to the core stage after warming up a quick disconnect in the engine section where a hydrogen leak was detected in the cavity between the ground and flight side plates of the quick disconnect. Teams warmed up the quick disconnect to attempt to reseat it and set …
