As the countdown continued Tuesday toward the cryogenic demonstration test, teams conducted final closeouts at the pad and performed other preparations for the test. Work will continue through the night, and all non-essential personnel will leave Launch Pad 39B by 3:40 a.m. EDT Wednesday. The launch director is expected to give a “go” to begin …
NASA remains on track for an Artemis I cryogenic demonstration test on Wednesday, Sept. 21. In the days since the previous launch attempt, teams have analyzed the seals that were replaced on an interface for the liquid hydrogen fuel line between the Space Launch System (SLS) rocket and the mobile launcher and adjusted procedures for …
The CAPSTONE team continues work on recovery efforts. The primary ongoing focus now is to heat the spacecraft’s propulsion system, which dropped below its operational temperature limit following the initial issue that put the spacecraft into safe mode on Sept. 8. Over the past few days, CAPSTONE’s power – though limited by the orientation of the …
NASA has adjusted the targeted dates for a cryogenic demonstration test and to the next launch opportunities for Artemis I, the first integrated flight test of the Space Launch System rocket and Orion spacecraft beyond the Moon. The agency will conduct the demonstration test no earlier than Wednesday, Sept. 21, and has updated its request …
Following the Sept. 10 update on CAPSTONE, mission owner and operator Advanced Space has provided an update on the mission. Read the full update from Advanced Space. During or shortly after a planned trajectory correction maneuver on Sept. 8, CAPSTONE suffered an issue that caused the spacecraft to tumble beyond the capacity of the onboard …
The CAPSTONE spacecraft executed a planned trajectory correction maneuver on Thursday evening, Sept. 8, and CAPSTONE mission controllers have since obtained telemetry confirming that an issue put the spacecraft in safe mode near the end of the maneuver. The CAPSTONE mission team has good knowledge of the state and status of the spacecraft. The mission …
After disconnecting the ground and rocket-side plates on the interface, called a quick disconnect, for the liquid hydrogen fuel feed line, teams have replaced the seals on the Space Launch System rocket’s core stage associated with the liquid hydrogen leak detected during the Artemis I launch attempt Sept. 3. Both the 8-inch line used to …
Engineers are making progress repairing the area where a liquid hydrogen leak was detected during the Artemis I launch attempt Sept. 3, and NASA is preserving options for the next launch opportunity as early as Friday, Sept. 23. Technicians constructed a tent-like enclosure around the work area to protect the hardware and teams from weather …
After standing down on the Artemis I launch attempt Saturday, Sept. 3 due to a hydrogen leak, teams have decided to replace the seal on an interface, called the quick disconnect, between the liquid hydrogen fuel feed line on the mobile launcher and the Space Launch System (SLS) rocket while at the launch pad. Performing the work at …
After standing down on today’s Artemis I launch attempt when engineers could not overcome a hydrogen leak in a quick disconnect, an interface between the liquid hydrogen fuel feed line and the Space Launch System (SLS) rocket, mission managers met and decided they will forego additional launch attempts in early September. Over the next several …
