Suggested Searches

This content has been archived.

ISS On-Orbit Status Report

    ISS Daily Summary Report – 2/03/2017

    Exposed Facility Unit (EFU) Adapter Transfer: Overnight ground controllers maneuvered the Japanese Experiment Module (JEM) Robotic Manipulator System (RMS) Small Fine Arm (SFA) to a position to remove the EFU Adapter from the EFU-5 location.  Once the EFU Adapter was removed, it was transferred and installed onto the JEM Airlock (JEMAL) Slide Table. The slide …

    Read Full Post

    ISS Daily Summary Report – 2/02/2017

    Exposed Facility Unit (EFU) Adapter Transfer: Ground Controllers maneuvered the Japanese Experiment Module (JEM) Remote Manipulator System (JEMRMS) and extracted the Small Fine Arm (SFA) from the SFA Storage Equipment (SSE). Overnight tonight the ground controllers will maneuver the SFA to grasp the EFU Adapter from the EFU-5 location.  Once the EFU Adapter has been …

    Read Full Post

    ISS Daily Summary Report – 2/01/2017

    Multi-Omics Collections: This morning the crew performed sampling in support of the JAXA Multi-Omics experiment. Various samples are collected and stowed in MELFI four times throughout the crew’s on-orbit duration in addition to a questionnaire and ingestion of fructooligosaccharide (FOS). The objective of Multi-Omics is to understand the gut ecosystem of astronauts in the space …

    Read Full Post

    ISS Daily Summary Report – 1/31/2017

    64 Progress (64P) Undock: 64P successfully undocked from the Docking Compartment 1 (DC-1) port this morning at 8:25 AM CST. Deorbit burn was at 11:34 AM CST today followed by atmospheric entry and destruction. Crew Autonomous Scheduling Test (CAST): The third of five sessions was completed today.  The objective of this session was to allow …

    Read Full Post

    ISS Daily Summary Report – 1/30/2017

    Fine Motor Skills (FMS): The crew performed their Flight Day 75 (FD75) FMS sessions this morning. Currently the crew is performing the test at a frequency of every 5 days for the first three months that they are onboard the ISS.  After FD90 the crew will transition to a frequency of FMS sessions every 14 …

    Read Full Post

    ISS Daily Summary Report – 1/27/2017

    H-II Transfer Vehicle (HTV)-6 Departure:  This morning, the crew finished closing out the Node 2 vestibule by demating all umbilicals and depressurizing the vestibule between HTV-6 and Node 2 in preparation for the unberth. Commands were sent to the release Common Berthing Mechanism (CBM) bolts prior to unberth.  Robotic Flight Controllers then maneuvered HTV-6 to …

    Read Full Post

    ISS Daily Summary Report – 1/26/2017

    Fluid Shifts Chibis Imaging Day 2: Due to yesterday’s issues with the Joint Station LAN (JSL), the final Flight Day 45 Chibis session for the 49S crew was rescheduled and performed this morning. The subject donned the Chibis device, and while the crewmember was exposed to the negative pressure (pulling the fluid feetward), then with …

    Read Full Post

    ISS Daily Summary Report – 1/25/2017

    Fluid Shifts Chibis Imaging Day 2: The Flight Day 45 Chibis session for the 49S crew was planned this morning, however due to Joint Station LAN (JSL) network issues the session had to be cancelled.  This Fluid Shifts session will be replanned for tomorrow.  Lighting Effects Vision Test: The crew performed a Numerical Verification and …

    Read Full Post

    ISS Daily Summary Report – 1/24/2017

    Story Time From Space Meniscus Demonstration: The crew narrated and recorded a video demonstration exploring how a fluid behaves in free fall (microgravity) and how acceleration compared to free fall will make fluid behave the same as it would on the ground (1-G environment). Story Time From Space combines science literacy outreach with simple demonstrations …

    Read Full Post

    ISS Daily Summary Report – 1/23/2017

    Minus Eighty Degree Celsius Laboratory Freezer for ISS (MELFI)-1 Autostop and Recovery: MELFI-1 went to Autostop mode Friday evening (during crew sleep). The Cold Stowage team performed troubleshooting including a rack reboot but remained in autostop.   Failure signature had anomalous values on the 120 and 28 volt inputs, as well as failure statuses on multiple …

    Read Full Post

Subscribe to this blog

Show Past Archives