The Fiber Optic Wing Shape Sensor system measures and displays the shape of the aircraft's wings in flight. The system also has potential for improving aircraft safety when the technology is used to monitor the aircraft structure.
Flight tests on NASA's Ikhana, a modified Predator B unmanned aircraft adapted for civilian research, are under way at NASA's Dryden Flight Research Center at Edwards Air Force Base in California. The effort represents one of the first comprehensive flight validations of fiber optic sensor technology.
"Generations of aircraft and spacecraft could benefit from work with the new sensors if the sensors perform in the sky as they have in the laboratory," said Lance Richards, Dryden's Advanced Structures and Measurement group lead.
The weight reduction that fiber optic sensors would make possible could reduce operating costs and improve fuel efficiency. The development also opens up new opportunities and applications that would not be achievable with conventional technology. For example, the new sensors could enable adaptive wing-shape control.
"Active wing-shape control represents the gleam in the eye of every aerodynamicist," Richards said. "If the shape of the wing can be changed in flight, then the efficiency and performance of the aircraft can be improved, from takeoff and landing to cruising and maneuvering."
Six hair-like fibers located on the top surface of Ikhana's wings provide more than 2,000 strain measurements in real time. With a combined weight of less than two pounds, the fibers are so small that they have no significant effects on aerodynamics. The sensors eventually could be embedded within composite wings in future aircraft.
To validate the new sensors' accuracy, the research team is comparing results obtained with the fiber optic wing shape sensors against those of 16 traditional strain gauges co-located on the wing alongside the new sensors.
"The sensors on Ikhana are imperceptibly small because they're located on fibers approximately the diameter of a human hair," Richards explained. "You can get the information you need from the thousands of sensors on a few fibers without the weight and complexity of conventional sensors. Strain gauges, for example, require three copper lead wires for every sensor."
When using the fiber optic sensors, researchers do not require analytical models for determining strain and other measurements on the aircraft because data derived with the sensors include all of the actual measurements being sought.
Another safety-related benefit of the lightweight fiber optic sensors is that thousands of sensors can be left on the aircraft during its lifetime, gathering data on structural health and performance. By knowing the stress levels at thousands of locations on the aircraft, designers can more optimally design structures and reduce weight while maintaining safety, Richards explained. The net result could be a reduction in fuel costs and an increase in range.
Further, intelligent flight control software technology now being developed can incorporate structural monitoring data from the fiber optic sensors to compensate for stresses on the airframe, helping prevent situations that might otherwise result in a loss of flight control.
By extension, the application of the technology to wind turbines could improve their performance by making their blades more efficient.
"An improvement of only a few percent equals a huge economic benefit," Richards said. "The sensors could also be used to look at the stress of structures, like bridges and dams, and possibilities extend to potential biomedical uses as well. The applications of this technology are mind-boggling."
NASA's Aeronautics Research Mission Directorate is supporting algorithm and systems development, instrument and ground test validation of the new sensor system. For more information on NASA's aeronautics research, visit:
PHOTO EDITORS: Three high-resolution photos to support this release are available electronically on the NASA Dryden web site at:
The photo numbers are ED08-0109-08, ED08-0016-20 and ED07-0287-08.
- end -
To receive status reports and news releases issued from the Dryden Newsroom electronically, send a blank e-mail message to firstname.lastname@example.org. To unsubscribe, send a blank e-mail message to email@example.com. The system will confirm your request via e-mail.
NASA Armstrong Flight Research Center news releases and other information are available automatically by sending an e-mail message with the subject line subscribe to firstname.lastname@example.org
To unsubscribe from the list, send an e-mail message with the subject line unsubscribe to email@example.com