Suggested Searches

Lunar Impact Monitoring Program

Mission statement: Use Earth-based observations of the dark portion of the Moon to establish the rates and sizes of large meteoroids (greater than 10s of grams or a few ounces in mass) striking the lunar surface.

Artist Concept of an Impact on the Moon.
Artist Concept of an Impact on the Moon.
NASA

Why it is important: The Meteoroid Environment Office is charged with developing an understanding of the meteoroid environment.  Lunar impact monitoring enables measurement of meteoroids in the 10s of grams to kilograms size range which are difficult to measure with other techniques.

When we observe: Observations are taken between New and 1st Quarter Moon and between Last Quarter and New Moon, when the solar illumination is between 10 and 55 percent. These conditions yield 10-12 observing nights per month.

Who is involved: This project is a joint effort involving NASA’s Meteoroid Environment Office and the Marshall Space Flight Center’s Space Environments Team. The participating individuals are/have been:

Richard Altstatt, Jacobs Technology (2006)
Rhiannon Blaauw, JSEG (2010-2017)
Emily Bowsher, NASA Academy Intern (Summer 2008)
Tiffany Clements, JSEG
Victoria Coffey, Space Environments Team (2006-2008)
Bill Cooke, Meteoroid Environment Office Lead
Anne Diekmann, Jacobs Technology (2008-2010)
Leanna Dugger, NASA USRP Intern (Summer 2007)
Steven Ehlert, JSEG (2014-2019)
Nick Hollon, Jacobs Technology Intern (Summer 2006)
Matthew Hosek, NASA USRP Intern (Summer 2010)
Aaron Kingery, JSEG
Heather Koehler, Meteoroid Environment Office (2006-2014)
Leah McCarrick, NASA Academy Intern (Summer 2007)
Danielle Moser, JSEG
Eric Ramesh, NASA Academy Intern (Summer 2010)
Leigh Smith, Space Environments Team (2006-2008)
Rob Suggs, Space Environments Team Lead, Lunar Impact Monitoring Lead
Ron J. Suggs, Space Environments Team (2006-2018)
Wesley Swift, Raytheon (2006-2010)

Observing facility: Observations are conducted at NASA Marshall Space Flight Center in Huntsville, Alabama at the Automated Lunar and Meteor Observatory (ALaMO). The facility consists of two observatory domes, a 15 meter (50 ft) tower with a roll-off roof, and an operations center with laboratory space. A second observatory in Chickamauga, Georgia (Walker County) was operational from September 15, 2007 to June 2011. The facility consists of a ground level building with a roll-off roof. This observatory was run remotely from Marshall Space Flight Center. A fourth 14 inch telescope was operated at New Mexico Skies Observatory from October 2011 to September 2012.

Lunar impact rate: On average, 33 metric tons (73,000 lbs) of meteoroids hit Earth every day, the vast majority of which harmlessly ablates (“burns up”) high in the atmosphere, never making it to the ground. The Moon, however, has little or no atmosphere, so meteoroids have nothing to stop them from striking the surface. The slowest of these rocks travels at 20 km/sec (45,000 mph); the fastest travels at over 72 km/sec (160,000 mph). At such speeds even a small meteoroid has incredible energy — one with a mass of only 5 kg (10 lbs) can excavate a crater over 9 meters (30 ft) across, hurling 75 metric tons (165,000 lbs) of lunar soil and rock on ballistic trajectories above the lunar surface.

The lunar impact rate is very uncertain because observations for objects in this mass range are embarrassingly few — a single fireball survey conducted by Canadian researchers from 1971 to 1985. Clearly more observations are needed if we are to establish the rate of large meteoroids impacting the Moon.

But why look at the Moon? We need to understand the numbers of meteoroids across a range of sizes so we can evaluate the threat to spacecraft.  Small meteoroids are measured with radar as they ablate in Earth’s atmosphere.  Larger meteoroids are less abundant so a large collecting area is needed to measure a statistically significant sample.  The surface of the Moon provides millions of square kilometers of collecting area we can see from Earth.

Meteor showers: It is well known that the Earth experiences meteor showers when it encounters the debris left behind by comets; so too does the Moon, though perhaps at not exactly the same time. On Earth these showers are capable of producing spectacular celestial fireworks displays, delighting the public. On the airless Moon, however, these showers are swarms of high energy projectiles, producing fireworks only when they strike the surface with tremendous force. During such times, the rate of shower meteoroids can greatly exceed that of the sporadic background rate and may pose a hazard to spacecraft. Looking for meteor shower impacts on the Moon at about the same time as they occur here on Earth will yield important data that can be fed into meteor shower forecasting models, which can then be used to predict times of greater meteoroid hazard in near-Earth space.

Observing lunar impacts: Looking for impacts on the Moon is as simple as pointing a telescope at its dark portion. When a meteoroid strikes the Moon, a large portion of the impact energy goes into heat and producing a crater; however, a small fraction goes into generating visible light, which results in a brilliant flash at the point of impact. This can be seen from Earth if the incoming meteoroid has enough kinetic energy. Just how much is “enough” depends on the equipment used in the observations.

In designing a system to look for these impact flashes, we need to take into account two important considerations. First, we want to see as faint as possible, and secondly we want to see as much of the lunar dark side as we can. The first is important because faint flashes are generally produced by smaller meteoroids, and the smaller the meteoroid, the more there are of them. More meteoroids mean more flashes and hence better statistics on which to base improved models. We can also get more flashes by monitoring as much of the lunar surface as possible, as the number of observed hits is going to be directly proportional to the amount of area seen by our instrument. That’s why the second point is important. It turns out that a modestly-wide field optical system (one with a fast focal ratio) meets both of these criteria nicely. So we perform simultaneous observations of the Moon using two 14” telescopes.

While you can look for impact flashes with just the telescope and your eyes, it is much better to have a record of the event that can be subjected to detailed analysis. A still camera is not a good choice, as you don’t know when the impact will occur. Impact flashes are short, usually less than a half-second, and you would be very lucky to press the shutter button in time to get a picture. Even if you did, you would miss the brightest part of the event, which occurs near the very beginning of the flash. A better choice is a low light level video camera, which records continuously at rates of 1/30th of a second. Hours of this data can be stored on a video tape or computer hard disk for later analysis.

And that is exactly what we do — we attach a Watec Ultimate H2 camera to each of our telescopes, and route the camera output into a Sony tape deck or Canopus video digitizer, which converts the video signal into a digital format that is stored on a hard disk. After an observing session, we look for flashes in the data. Our first impact was found by someone simply looking through a couple of hours of video. This can be quite tedious, however, and tired humans can easily miss a short impact flash, so custom computer software was developed to look for the flashes. If one is found, additional software is then used to extract detailed information on the flash — its brightness as a function of time (light curve), where it was seen on the Moon, if it was due to a meteor shower, and so forth. Using this information, we can estimate the mass or size of the meteoroid. If it is a sporadic meteoroid, all we can do is put limits on the size, as its speed can range from 20 km/sec (2 miles/sec) all the way up to 70 km/sec (44 miles/sec). If it is a shower meteoroid, then things are better because every member of a meteor shower moves with the same, known speed. This allows us to calculate a single, less uncertain size estimate.

The above paragraph gives a greatly simplified summary of the analysis. In practice, it is much more detailed, as a flash on the video may be caused by something other than a meteoroid striking the Moon. Most of the flashes we see last for only a single video frame (1/30th of a second) and are due to cosmic rays striking the camera’s CCD chip. If we had only one telescope we would discount any flash that is only one frame in duration, blaming a cosmic ray as the culprit. However, in doing so, we would probably miss some of the smaller impact events. A better way of eliminating cosmic rays is to use two telescopes of similar characteristics, observing at the same time — this is what we do at the ALaMO. A given cosmic ray can only strike one camera; therefore any flash observed simultaneously with both instruments cannot be a cosmic ray.

There are other possible causes of flashes, such as reflections or glints from satellites and orbital debris that happen to move between our observatory and the Moon, or point meteors, which are meteors in Earth’s atmosphere that are coming straight at the observer. Of course point meteors don’t hit, but they produce a flash when they ablate. These flashes can be eliminated by looking at the light curve — an impact flash has a sharp onset, followed by a slower decrease in the amount of light, whereas a point meteor will have a light curve that appears more symmetrical. Flashes produced by satellites can be removed by determining whether or not the flash moves in the video; if it does, then it is caused by a satellite. If the satellite is moving quickly, or the flash consists of a single frame, then this “moving in the video” discriminator is less reliable. The addition of a third telescope at a distance (North Georgia in our case) helps us discriminate against sun glints from orbiting debris via parallax. If the flash shifts position against the background Moon field when comparing images taken from the AlaMO and our second observatory site in Georgia, then it is probably caused by glint from a satellite or orbital debris. If there is no shift of position between flashes viewed from the two different sites, then it is likely a true impact flash. Noise can also masquerade as flashes in the video recording; recording directly to hard drive (instead of recording to videotape and then transferring to hard drive) reduces noise. And using two telescopes to observe simultaneously helps to eliminate this problem.

Part of a comprehensive strategy:  Monitoring the Moon for impacts is only part of the equation for determining the rate of large meteoroids hitting the Moon and the risk they pose to future space exploration. In order to get at the size of the impactor, we must figure out how much of its energy is converted into light. This amount, expressed as a fraction of the total energy, is called the luminous efficiency, and it depends on the speed of the meteoroid and the nature of the lunar surface where it hits. Current estimates of impact luminous efficiency are little more than guesses, so the Meteoroid Environment Office and the Space Environments Team performed a small series of experiments in which lunar surface simulants were struck by small projectiles fired from hypervelocity guns at speeds up to 6 km/sec (13,000 mph). The flashes from these impacts are recorded by a camera like that attached to our telescopes. A comparison of the amount of light energy produced by the flashes to the known kinetic energies of the projectiles will give us direct calculations of the luminous efficiencies. The values can then be applied to our observations and improved meteoroid size or mass values obtained.

View More
Impact Candidates