NASA News

Text Size

Allard Beutel
Headquarters, Washington
(Phone: 202/358-4769)

Jessica Rye
Kennedy Space Center, Fla.
(Phone: 321/867-2468)

June 25, 2004
 
RELEASE : S04-17
 
 
Space Shuttle Processing Status Report: S04-17
 
 
The Space Shuttle fleet is housed and processed at NASA's Kennedy Space Center (KSC), Fla. The order the Space Shuttles are listed in this report does not necessarily reflect the chronological order of future missions.

Discovery (OV-103)

In the Obiter Processing Facility, Discovery continues its scheduled power-down period for its Return to Flight mission, STS-114, to the International Space Station. The Return to Flight modifications, including the orbiter boom sensor system wiring and preparations for installation of the wing leading edge sensors are progressing on schedule.

The Forward Reaction Control System, which provides the thrust for attitude (rotational) maneuvers (pitch, yaw and roll) and for small velocity changes along the orbiter axis (translation maneuvers), was installed Wednesday.

Atlantis (OV-104)

Technicians are processing Atlantis in the Orbiter Processing Facility in support of its future mission. The four-month power-down period continues so that workers can perform Return to Flight modifications, as well as structural and baseline wire inspections. Following the modification period, Atlantis is scheduled to be powered-up on Oct. 1, 2004.

Installation of the left-hand carrier panels, the Thermal Protection System panels that attach the Reinforced Carbon-Carbon panels to the wing leading edge, is underway. On the right-hand side, all of the 22 panels and T-seals, the C-shaped seals that fit between each panel, are assembled and ready for installation.

Endeavour (OV-105)

Space Shuttle Endeavour is in its Orbiter Major Modification period, which began last December. Electrical modifications continue in the crew module. Wire inspections are ongoing in the Environmental Control and Life Support System bay.

Bead blasting of Endeavour's body flap area, right-hand wing leading edge and dome heat shield area continues. Bead blasting is a process using a pressurized pneumatic gun containing silica carbide, plastic pellets or glass beads to remove primer, paint and corrosion from orbiter vehicle surfaces. Flex hose inspections in the Environmental Control and Life Support System are underway.

Previous Space Shuttle processing status reports are available on the Internet at:

http://www-pao.ksc.nasa.gov/kscpao/status/status.htm

For information about NASA's Return to Flight efforts on the Internet, visit:

http://www.nasa.gov/news/highlights/returntoflight.html

For information about NASA and agency programs on the Internet, visit:

http://www.nasa.gov

 

- end -


text-only version of this release

To receive status reports and news releases issued from the Kennedy Space Center Newsroom electronically, send a blank e-mail message to ksc-subscribe@newsletters.nasa.gov. To unsubscribe, send a blank e-mail message to ksc-unsubscribe@newsletters.nasa.gov. The system will confirm your request via e-mail.