Text Size
NASA Armstrong Fact Sheet: Aerodynamic Truck Studies
February 28, 2014

Air flow testing on aerodynamic truck Application of aerodynamic design principles to the design of large truck cabs by NASA Dryden researchers in the mid-1970s led to the adoption of those standards by most manufacturers of large trucks on the road today. (NASA Photo) During a decade spanning the 1970s and 1980s, Dryden researchers conducted tests to deter-mine the extent to which adjustments in the shape of trucks reduced aerodynamic drag and improved efficiency. During the investigation of truck aerodynamics, the techniques honed in flight research proved highly applicable.

During the tests, the vehicle's sides were fitted with felt tufts, or strings, that showed airflow. The investigators concluded that rounding the vertical corners front and rear reduced drag by 40 percent, yet decreased the vehicle's internal volume by only 1.3 percent. Rounding both the vertical and horizontal corners cut drag by 54 percent, while losing only three percent of internal volume.

The first phase involved a cab-over tractor-trailer, modified by rounding all of its front corners and edges. In addition, technicians attached sheet metal fairings over the cab's roof and sides as far back as the trailer. This covering closed the open space between the cab and trailer. During the phase one research, researchers found that in highway driving at 55 miles per hour, rounding the corners and fairing the space to close the gap between the truck's cab and trailer resulted in a significant reduction in aerodynamic drag, resulting in 20 to 25 percent lower fuel consumption than the standard vehicle. The improvements soon spurred design changes in production trucks, as many truck manufacturers subsequently incorporated similar modifications on their products.

Air flow testing on aerodynamic truckThis photograph illustrates a standard passenger van modified at the Dryden Flight Research Center to investigate the aerodynamics of trucks. The resulting vehicle-re-fashioned with sheet metal-resembled a motor home, with rounded vertical corners on the vehicle's front and rear sections. For subsequent tests, researchers installed a "boat tail" structure, shown in the photograph. (NASA photo) The second phase conducted on the modified passenger van entailed such modifications as rounding the vertical and horizontal corners, as well as adding a "boat tail" structure to the rear of the vehicle and a faired underbody. The modified van-with rounded vertical corners front and back-experienced 40 percent less drag than the standard configuration. With the rounding of horizontal corners as well, drag reduction rose to 54 percent. A second group of tests added a faired underbody and a boat tail, the latter feature resulting in an additional drag reduction of about 15 percent.

Based on the research conducted at NASA Dryden, many truck manufacturers subsequently incorporated similar improvements and design modifications in their production trucks.

Image Token: 
Image Token: 
Image Token: 
Page Last Updated: February 28th, 2014
Page Editor: NASA Administrator